MPG Movies of Machines Controlled by the CamPod

MPG Movies of Machines Controlled by the CamPod
Taig Micro Mill With Servo Motors This movie is of a Taig Micro Mill with Servo Motors cutting acrylic connector panel for a motor controller. The motor controller for the mill uses the Geckodrive Servo Drive modules. The controlling Software is SuperCamXp via the USB CamPod. You may note that at the top of the SuperCamXp screen is the output of a USB camera that is focused on the working area of the Taig Micro Mill. SuperCamXp has the Camera command to permit simultaneous watching the progress of the machine on the camera as well as see the graphic animation.	Movie MiniRobo Engraving This movie is of the Minirobo engraving on plastic. The controller uses Geckodrive G201's. SuperCamXp is driving the controller via a USB cable to the CamPod that has a parallel port connector on it.	MiniRobo engraving foral pattern This movie is of the MiniRobo going throught the motions of engraving a floral pattern on plastic. The tool is not actually touching the surface. It shows the real time animated screen on the laptop that is controlling the MiniRobo.