|Gecko Powered Three(3) Axis CNC Brushed Servo Motor Controller|
|Part Number: EMC-XYZ-GSBX|
XYZ Servo Motor Controller with internal 40 Volt Power Supply.
|One(1) 10 ft. Male to Male Parallel Printer Port Cable. |
In Metal Box 12 x 12 x 6 inches
Input voltage required is 120/240 VAC.
|Pictures Gecko Powered Three(3) Axis CNC Brushed Servo Motor Controller|
This is the connector panel of the EMC-XYZ-GSBX controller. There is a power on/off switch, two relay controlled main power recepticals, the parallel port female connector, one DB15 female connector for each Servomotor.
This is the inside of the EMC-XYZ-GSBX. The Toroid transformer has a winding added to provide a internal +5 Volt for the logic circuits. There is a fuse for the main power entering the box. The fan assures proper air circulation. The Heatsink attached to the Gecko motor drivers is exceptionally large. The power control relays are embedded on the printed circuit board.
With the cover off, it is easy to access the Gain, Damp, and Current Limit trimpots on the Gecko Servo Motor Drivers. There are LED's that indicate relay, +5 Volt and Motor Voltage Status.
Home Page at http://www.super-tech.com