SuperCamXp StatusBar at the Bottom of Main Screen
This is the Status Bar across the bottom of the main screen of SuperCamXp.
By clicking on the panels you can change the properties of SuperCamXp.

USB OK panel displays the status of the USB device channel. NO USB is displayed when no active device responded to then initial polling at program first load. By clicking on this panel the CamPod Control form is displayed.

Polling Status panel displays the status of the polling for machine movements. The message 'Simulate Polling' is displayed when the attached machines movement will be simulated but no movement will occur.

Relay A panel displays the status of the Relay A property. By clicking on the panel the property is toggled on and off.

Relay B panel displays the status of the Relay B property. By clicking on the panel the property is toggled on and off.

X panel dislays the status of the Home Limit Switch for the X axis switch. When the legend is highlighted the switch is engaged.

Y panel dislays the status of the Home Limit Switch for the Y axis switch. When the legend is highlighted the switch is engaged.

Z panel dislays the status of the Home Limit Switch for the Z axis switch. When the legend is highlighted the switch is engaged.

Machine Coordinates panel has a green background and displays the current X,Y,Z coordinates.

Units/Time Reference panel displays the current Units and Time Reference settings.

Driver Status panel displays Selected or Deselected depending on the current state of the Controller Drivers Status. By clicking on this panel it will toggle between enabled motors and disabled motors. When the status is Deselected the motors should be easy to turn by hand. When Selected stepper motors will not easily be moved by hand, servo motors will actively oppose movement of the motor shafts.

Motion Status panel displays the current status of the motion engine operating as a background thread.

Z Axis Spindle panel displays the status and distance the spindle cutter is in relation to the material surface coordinate. It will display cutting when the cutter is beneath the surface of the material.


Command Menus Arc Array BMP Change Order Circle Copy Erase Line Join Move
Extend Trim Info On Off Moveto DXF Mirror HPGL Rotate Editcnc Grid Export Gcode Scale Snap
Swapend Point Plot Buff Plot Item Text Text Center Text Fit X Y Z



ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form



Home Page at http://www.super-tech.com
http://www.super-tech.com/root/SuperCamXp-StatusBar-Btm.html
Published 7/6/2017 4:28:16 PM
Copyright 2016 Dennis Bohlke