|Draw an Arc||The Arc command is used to draw arcs.
The Arc command can be selected from:
The arc command prompts for input for the Center, Start Angle, End Angle and Radius of the arc.
Dimensions for the arc are prompted for in the command line, which is located below the graphics area.
The first prompt, Arc Center: <Pick|Done>:.
Then it prompts, Start Angle: <Pick|Done>:
Then it prompts, End Angle: <Pick|Done>:
The Last prompt, Radius: <Pick|Done>:
The arc is now drawn in the graphics area and the command is done, an arc graphic item is added to the end of the drawing list.
The arc will be drawn in the direction (CW-clockwise or CCW-counterclockwise) that has already been selected with the setarcdir (set arc direction) command.
Arc graphic items can be changed into polylines with the Editi command.
Arc command console area displayed messages during arc command execution.
Home Page at http://www.super-tech.com
Published 2/10/2017 8:09:40 AM
Copyright 2016 Dennis Bohlke