Select Command

The Select command enables the motor controller.

This engages the motors with a low current if they are stepper motors.

The CamPod makes Pin 14 on to be made Low.

Servo motors are selected and will maintain their location.

When configured for servo motors the Pin 17, on the CamPod, is made high for the amount of time defined by the Servo Start delay.

Command Menus Arc Array BMP Change Order Circle Copy Erase Line Join Move
Extend Trim Info On Off Moveto DXF Mirror HPGL Rotate Editcnc Grid Export Gcode Scale Snap
Swapend Point Plot Buff Plot Item Text Text Center Text Fit X Y Z

ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form

Home Page at
Published 7/6/2017 4:27:20 PM
Copyright 2016 Dennis Bohlke