Mconfig/Speeds Command

This form has detail paramenters that control the speed of movement of the attached machine.

Z Altitude is the offset above the defined coordinate of the material surface that rapid travel moves will be made between cuts.

Material Surface contains the Z axis coordinate of where the material surface is.

Z Depth is the offset below the surface coordinate that cutting moves will be made

Dsp Tool Width this textbox displays the diameter of the cutting swath displayed in the drawing area of the main screen during animation of cutting moves.

Jog Mode this determines how jog moves are handled when the check is on the attached machine moves until the arrow key is not depressed. When it is not checked the machine moves one jog increment per arrow key hit.

Units of Length this can be Inches, MM or CM.

Reference this can be Minute or Second and refers to the time reference for motion speed parameters.

Change Reference Units this button changes the time reference toggling between Second and Minute.

Travel Speed this is the starting speed for rapid travel moves.

Travel Slew this is the speed that it speeds up to.

Travel Ramp this is the rate of acceleration and deceleration.

Cut Speed this is the starting speed for cutting moves.

Cut Slew this is the speed that is speeds up to for cutting moves.

Cut Ramp the is the rate of acceleration and deceleration.

Jog XY Incr this is distance of movement for each arrow key stroke if the Jog Mode check is off.

Z Travel Speed this is the starting speed for rapid travel moves.

Z Travel Slew this is the speed that it speeds up to.

Z Travel Ramp this is the rate of acceleration and deceleration.

Z Cut Speed this is the starting speed for cutting moves.

Z Cut Slew this is the speed that is speeds up to for cutting moves.

Z Cut Ramp the is the rate of acceleration and deceleration.

Jog Z Incr this is distance of movement for each arrow key stroke if the Jog Mode check is off.


Command Menus Arc Array BMP Change Order Circle Copy Erase Line Join Move
Extend Trim Info On Off Moveto DXF Mirror HPGL Rotate Editcnc Grid Export Gcode Scale Snap
Swapend Point Plot Buff Plot Item Text Text Center Text Fit X Y Z



ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form



Home Page at http://www.super-tech.com
http://www.super-tech.com/root/cmmd_speeds.html
Published 2/10/2017 8:10:19 AM
Copyright 2016 Dennis Bohlke