www.super-tech.com
CNC Chinese Router Table with SuperCamXp and USB ArmPod Controlling the Motion Movements

CNC Chinese Router Table run by SuperCamXp with an USB ArmPod.
With sheet of material mounted ready to be cut.

CNC Chinese Router Table run by SuperCamXp with an USB ArmPod.
This is one of the parts that will be made with the Router Table.
It is the end plate for a large air filtration box.

CNC Chinese Router Table run by SuperCamXp with an USB ArmPod.
This is one of the parts that will be made with the Router Table.
It is the end plate for a large air filtration box.

CNC Chinese Router Table run by SuperCamXp with an USB ArmPod.Back side of the Gantry showing the Cable way.

This is the original electronics for running the router table.

Another view of the orginal controller electronics.

These are the stepper motor drivers. From them I was able to trace the step and direction signal wires.

This is the USB ArmPod board mounted on in the control box.

This shows the electrical hookup and the VFD for the router spindle.

This is the power supply to run the Stepper motors for Coordinate positioning.

This is the USB ArmPod hookup completed.

A DB25 Male connector with wires is plugged into the USB ArmPod and then the wires are wire nutted to the Step and Direction lines.

A DB25 Male connector with wires is plugged into the USB ArmPod and then the wires are wire nutted to the Step and Direction lines.

This is the Laptop running SuperCamXp and controlling the table with aa USB ArmPod. The screen shot shows it ready to import a DXF file.


Home Page at http://www.super-tech.com

http://www.super-tech.com/root/cnc.asp
Copyright 2016 Dennis Bohlke
Revised 03/12/16 dlb