7. Drill the holes in the part.
7.1 Use PLOTITEM command to select the points that correspond to the holes that have to be drilled.
7.2 Answer NO to the first question and make a progressively deeper cut.
7.3. Set the Final Cut Depth to 0.260 inches.
7.4. Set the Increment of Cut to be 0.031 inches.
7.5. Select the Pecking Cycle method of executing the tool path.
7.6. Execute the tool path, Light cutting oil should be used to increase end mill life.

Home Page at http://www.super-tech.com

Copyright 2016 Dennis Bohlke
Revised 03/12/16 dlb