9. Cut Face Plate depression. This cut is 0.062 inches deep. The objective is to leave a protrusion that will correspond to the face plate configuration of a NEMA 23 stepper motor.
9.1. Use PLOTITEM to select the lines that correspond to the tool path for cutting the face plate.
9.2. Make a progressively deeper cut.
9.3. Set Final Cut Depth to 0.062 inches.
9.4. Use the default value of 0.021 inches for the Incremental cut. That is the previous cuts setting.
9.5. Select Pecking Cycle method of executing the tool path.

Home Page at http://www.super-tech.com

Copyright 2016 Dennis Bohlke
Revised 03/12/16 dlb