www.super-tech.com
Select Command
The Select command enables the motor controller.

This engages the motors with a low current if they are stepper motors.

The CamPod makes Pin 14 on to be made Low.

Servo motors are selected and will maintain their location.

When configured for servo motors the Pin 17, on the CamPod, is made high for the amount of time defined by the Servo Start delay.



Home Page at http://www.super-tech.com

http://www.super-tech.com/root/cnc.asp
Copyright 2016 Dennis Bohlke
Revised 03/12/16 dlb