|CNC XY Controller, Motors and Cables for Plasma Torch Tables|
Part Number: EMC-XY-GBT-K2B
|Micro Stepping Controller for Two Motors|
Geckodrive G201 module for each motor
2000 Steps Per Revolution
NEMA34 Step Motors with 1290 oz/in Torque
Double 1/2 Inch Shafts with Flats
Motor Cables made with 20 AWG Wire
DB9 Female Connector for Each Motor
Home Limit Switch Circuit for Each Motor
Two(2) 10 Ampere Relays for Torch or Spindle Control
Terminal Block on Connector Panel for Relay Contacts
Internal Power Supply
120 or 240 VAC Input
Parallel Port Step and Direction
USB CamPod and Mach3 Compatible
All you need to control a Computerized CNC Plasma Torch Table that uses two motors for positioning, one motor per Axis X and Y.
The Motors have 1/2" shafts that work well with a 1" spur gear and rack drive setup for a Plasma Table, this provides a step size of 0.00157295 inch.
When the motors are made to turn ten(10) revolutions per second, 600 rpm, the table will be moving 31.4 inches per second or 1887 inches per Minute.
The controller is compatible with Mach3 or the USB CamPod with SuperCamXp.
|Pictures Gecko Powered Two(2) Motor CNC Controller Kit|
Three 1290 oz/in, Double Stack Stepper Motors Manufactures Drawing
Connector Panel with Cables Hooked Up
Connector Panel with DB25 Female Parallel Port Connector
Terminal Block for Relay Contacts
DB9 Female Connectors for Each Motor
15 x 15 x 15 Box with everything in it
Home Page at http://www.super-tech.com