|USB CNC Two(2) Axis Micro Stepping Three(3) Motor Controller|
Part Number: USB-XYY-MUBT
USB CNC Plug and Play compatible with Windows XP and Vista
Configured to run three(3) motors on two(2) axis with the Y motors synchronized. This is for driving grantry styled machines with a motor for each end of the gantry bridge.
|Micro Step Unipolar Motor Driver Configuration|
Requires Six(6) Wire Stepper Motors
By Default 1600 Steps per Revolution
Jumper Configurable 400, 800, 1600, 3200 Steps Per Revolution
Three(3) Ampere Per Phase Maximum Current Capacity
Each Motor has it's Own Drive Electronics
Each Motor has Home Limit Switch Circuit with Low-Pass Filter
Each Motor has a Nine(9) Pin DB9 Female Connector
Two(2) Controlled Relays with Contacts presented on Terminal Block on Connector Panel
Internal 24 Volt 6.5 Amp. Power supply, 150 Watt 120/240 switchable
In metal utility box 10 x 10 x 4 inches.
Connector Panel of the USB-XYY-MUBT Micro Stepping Coordinate Positioning Motor Controller. USB Reset, Terminal Block #1, Motor X, Motor Y1, Motor Y2, Power ON/OFF Switch.
SuperCamXp CD and Users Guide is include with the purchase of the Controller. SuperCamXp is a graphical user interface for machine tool control.
Home Page at http://www.super-tech.com