USB CNC Three(3) Motor Bundled CNC XY Machine Control Kit
USB CNC Plug and Play compatible with Windows XP and Vista and Windows 7

Configured to run two(2) axis machine tools with the Y motors synchronized. This is for driving grantry styled machines with a motor for each end of the gantry bridge.

Typical Use:
Two(2) Axis XY Grantry type tables with NEMA 23 size stepper motors
Plasma Tables
Small Routers
Laser Engravers
Glue Spreaders

Key Features:
XYY configuration.
The Two(2) Y Motors are Synchronized for Driving a Gantry at Both Ends
USB interfaced, USB Cable attached to Controller

Shipping Box
14 X 14 X 14 28 lbs Controller, Motors and Cables

Micro Step Unipolar Motor Driver Configuration
Requires six(6) wire stepper motors
By Default 1600 Steps per Revolution
Jumper Configurable 400, 800, 1600, 3200 Steps Per Revolution
Three(3) Ampere per phase maximum current capacity
Each Motor has it's Own Drive Electronics
Each Motor has Home Limit Switch Circuit with Low-Pass Filter
Each Motor has a Nine(9) Pin DB9 Female Connector
Motors have 1/4 inch Diameter Shafts
Motors are Double Shafted
Crush Proof Home Limit Switch Pre-Wired to Each Motor
Two(2) Control the Power to Two Main Power Recepticals on Connector Panel
Internal 24 Volt 6.5 Amp. Power supply, 150 Watt 120/240 switchable.
In metal utility box 10 x 10 x 4 inches.

Three(3) 300 oz-in Double shafted NEMA 23 stepper motors
Three(3) ten(10) meter motor cables
SuperCamXp CNC Machine Tool Control Graphics Program

Price List
Detailed InformationPart# USB-XYY-MUBX-K3  XYY, USB, Unipolar, 1600 Step/Rev, 3 Amp., Micro Step Motor Controller two(2) axis, drives four Unipolar motors. The two Y motors are synchronized. Two(2) Control the Power to Two Main Power Recepticals on Connector Panel. Internal power supply, 24 Volt, 6.5 Amp., 150 Watt, 120/240 switchable. With SuperCamXp. USB interface with SuperCamXp. Three(3) motors and the cables included. USB cable included with controller. In metal utility box 10 x 10 x 4 inches.   Weight: 25 lbs........$1,295.00

Click on CheckBox to include in Order
- Click on 'AddToCart' to Create New Order or Add Item

Home Page at
Copyright 2016 Dennis Bohlke
Revised 03/12/16