USB Three Axis Half Stepping Four(4) Motor Controller

Typical Use: XYZ Grantry type tables with NEMA 23 size stepper motors, engravers, glue spreaders, plasma tables, small routers.

Configured to run three axis with the Y motors synchronized. This is for driving grantry styled machines with a motor for each end of the gantry bridge.

XYYZ configuration.

    USB interfaced.

    Unipolar motor driver configuration. Requires six(6) wire stepper motors.

    400 Steps per Revolution.

    2.5 Ampere per phase maximum current capacity.

    Each motor has it's own drive electronics.

    Each motor has home limit switch circuit.

    Each motor has a DB9 female connector.

    Three(3) Axis,

    Step Motor Controller.

    The two Y motors are synchronized for driving a gantry at both ends.

    Internal 24 Volt 6.5 Amp. power supply, 150 Watt 120/240 switchable.

    In metal utility box 10 x 10 x 4 inches.

SuperCamXp CNC Machine Tool Control Graphics Operating System for Windows XP Desktop computers.

Price List

Click on CheckBox to include in Order
- Click on 'AddToCart' to Create New Order or Add Item

Home Page at
Copyright 2016 Dennis Bohlke
Revised 03/12/16