USB CNC Three(3) Axis XYZ Micro Stepping Three(3) Motor Controller

(none)
Part Number: USB-XYZ-MUBX

USB CNC Plug and Play compatible with Windows XP and Vista

Typical Use:
Three(3) Axis XYZ Machines with NEMA 23 Size Stepper Motors
Taig Micro Mills
Laminate Routers
Dremel Drills
Plasma Torch Tables
Engravers

Key Features:
XYZ Motor Configuration
USB interfaced, USB cable attached to the Controller
Configured to Run Three(3) Axis XYZ Machines

Micro Stepping Unipolar Motor Driver Configuration
Requires Six(6) Wire Stepper Motors
By Default 1600 Steps Per Revolution
Jumper Configurable 400, 800, 1600, 3200 Steps Per Revolution
Three(3) Ampere Per Phase Maximum Current Capacity
Each Motor has it's Own Drive Electronics
Each Motor has a Trim Pot for Adjusting Motor Phase Current
Each Motor has Home Limit Switch Circuit with Low-Pass Filter
Each Motor has a Nine(9) Pin DB9 Female Connector
Two(2) Relay Controlled Main Power Recepticals
Relay Contacts are Rated at 10 Ampere
Power Supply is Internal 24 Volt 6.5 Amp., 150 Watt 120/240 Switchable
Completely Housed in Grey Metal Utility Box 10 x 10 x 4 inches
Shipping Weight is 14 lbs

Includes:
SuperCamXp Graphical CNC Machine Tool Control Program

Price List
XYZ, USB, Unipolar, 1600 Step/Rev, 3 Amp., Three(3) Motor, Three(3) Axis,  Step MotorPart# USB-XYZ-MUBX-K3  XYZ, USB, Unipolar, 1600 Step/Rev, 3 Amp., Three(3) Motor, Three(3) Axis, Micro Step Motor Controller. Two(2) Relay Controlled Main Power Recepticals. Internal power supply, 24 Volt, 6.5 Amp., 150 Watt, 120/240 switchable. USB interface with SuperCamXp. Three(3) 300 oz/in NEMA 23, Double 1/4 inch shafts, Stepper Motors and three(3) six(6) foot motor cables included. USB cable included with controller. In metal utility box 10 x 10 x 4 inches.   Weight: 28 lbs........$1,295.00

Click on CheckBox to include in Order
- Click on 'AddToCart' to Create New Order or Add Item
Pictures of USB CNC Three Axis XYZ Micro Stepping Unipolar Three(3) Motor Controller

Connector Panel of USB CNC Micro Step Motor Controller Box
Relay Controlled Power Recepticals
DB9 Female Connector for each Stepper Motor
USB Reset, Power ON/OFF Switch

SuperCamXp CD with Manual in Envelope
USB CNC Micro Step Motor Controller Box

USB cable and Power Cord are attached to the USB CNC Micro Step Motor Controller Box

USB CNC Micro Step Motor Controller Box hooked up to Laptop and Motors

Controller Box With Cover Off
Shows internal power supply with 120/240 switch

Looking down on the inside of the Controller Box
Trimpots are for adjusting Stepper Motor Phase Currents
M1 and M2 jumpers are for setting the step resolution




Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=PN_USB-XYZ-MUBX
Copyright 2016 Dennis Bohlke
Revised 03/12/16