Desktop CNC Taig Micro Mill with Servo Motors

Taig Long Bed Micro Mill with Brushed DC Servo Motors for Computer Controlled Coordinate Postioning
Completely Assembled and Tested before Shipping

Strong Smooth Reliable Movement! Built for Heavy Duty Work

* Ready to go with Mach3 Parallel Port Machine Control Program.
* Compatible with SuperCamXp and CamPod the USB CNC interface.

Taig Micro Mill
* Base Mechanism is Taig-2019CR-ER Micro Mill
* Axis Travel Distances 11.75" X, 4.75" Y, 5.25" Z.
* 20 Turns Per Inch Lead Screws on All Three Axis.
* Precision Spindle with Runout Less than 0.0005 inch.
* Spindle Motor is 1/4 hp, 120 VAC.
* Spindle Pulleys have six V-belt slots for setting speeds.
* Spindle Speeds are 1050,1650, 2600, 4200, 6700, 10600.
* Spindle Accepts ER-16 Collets.
* Crush Proof Home Limit Switches Wired and Tested

CNC Motor Controller
* Controller and Motors are the Part Number: EMC-XYZ-GSBX-K3C
* Motor Controller has Standard Parallel Printer Port Connector.
* Internal Power Supply of 40 Volts, 16.6 Ampere, 120 or 240 VAC input.
* GeckoDrive G320 Servo Drive Modules.
* Relay Power Control for Spindle Motor and Auxilary Device.

TAIG Accessories Included
Milling Vise
2 End Mills - 3/32 and 3/16 inch
ER Collet Set - 3/8, 5/16, 1/4, 3/16, 1/8, 1/16 inch
* Three Brushed Servo Motors, With 500 CPR encoders.
* 48 Inches Per Minute Rapid Travel Speed.
* 2000 Increments of Resolution Per Revolution.
* 0.000025 inch (0.000635mm) Movement Per Increment.

* Three Brushed Servo Motors, With 250 CPR encoders.
* 80 Inches Per Minute Rapid Travel Speed.
* 1000 Increments of Resolution Per Revolution.
* 0.000050 inch (0.001270mm) Movement Per Increment.

Pictures of Desktop CNC Taig Mill with Brushed DC Servo Motors

Taig Mill with Servo Motors Attached

Taig Mill with Servo Motors Attached

Taig Mill with Servo Motors Attached

This shows the Z axis servo motor.

This picture shows the X Servo Motor and the attached Limit Switch.

Y Servo Motor and the attached Limit Switch.

The servo motors with the adapter plate that mates the servo motors to the mill.

Gecko Powered Servor Motor Controller, Cables, CamPod and SuperCamXp CD

Connections to the CNC Controller.

This shows the end of the Y Lead Screw without the Servo motor Mounted.

This shows the Z axis limit switch and the spindle motor On/Off switch.

This is a picture looking under the Table Saddle. It shows the Brass Y-Nut on the Y Lead Screw. The are allen head screws to adjust the tension of the nut to the lead screw.

This is text engrave with a high relief of 0.125 inches in aluminum plate.
  




Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=ServoMill
Copyright 2016 Dennis Bohlke
Revised 03/12/16