SuperCamXp-GraphicsInfo-Gcode
G-code configuration

These are the parameters that pertain to the importing of G and M code files.


G-code this is the path of the last G-code file imported.

Last File Name this is the file name of the last file imported.

SCALE this is the scale factor to be used when importing files.

OFFSET this is the offset to be added to coordinates when importing files.

Single Step this button will cause the code to be single stepped through.

Feed Rate this is MENU or AUTO, when in MENU mode the preset speeds are used. When in AUTO mode the feed rate parameters embedded in the G-code file are followed.

Units this is the units used to define the feed rates.

Display this is the what will be displayed when the file is imported.

ROTATE this button can be NO or YES. When YES the tool path is rotated ninety(90) degrees when imported.





ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form



Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=SuperCamXp-GraphicsInfo-Gcode
Copyright 2016 Dennis Bohlke
Revised 03/12/16