GraphicsInfo - Grid and Snap Configuration Dialog
Grid and Snap Configuration

Paramenters associated with the grid and snap features. Also parameters pertaining to the drawing and execution of circles and arcs.


Snap Size this is the spacing of the mouse snap.

Snap Status this shows the current status, it will be either on/off.

Grid Size this is the spacing between grid points.

Grid Status this shows the current status, it will be either on/off.

Z Grid Coordinate this is the Z coordinate at which a grid is drawn when in 3D display mode.

Display Arc Cords this is the number of cords a circle or arc are segmented into when drawn to the graphics area of the screen.

Mechanism Arc Cords this is the maximum number of cords a circle or arc is segmented into when executed on the machine. The adaptive cords feature reduces the number of cords if the segment length is less than the distance the machine will move in the time of the ramp interval at cutting slew speed. This assures the smoothest curves possible.

Zero Icon when checked an icon is drawn at 0,0,0 when in 3D display mode.

Point Icon a small cross icon is used instead of a pixel for points in drawings. This makes it easier to see drill points.

Machine Coordinate Display When checked a Dialog Form with the mechanism's current location coordinates are displayed independent of the SuperCamXp main form.

Auto Limit Adjust When the machine location is manually set it changes the limit boundaries when checked.

Apply this applies the changes made.





ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form



Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=SuperCamXp-GraphicsInfo-GridSnap
Copyright 2016 Dennis Bohlke
Revised 03/12/16