SuperCamXp-UsbCntrl-CurStat
Current Status of the USB interface to the CamPod

Shows the coordinates of the X, Y and Z axis.

Shows the status of Home Limit Switches.

Shows the Status of Relays.


X,Y,Z the text box to the left is the current X axis coordinate. The text box next to it is the current status of the X Home Limit Switches.

Pause intended to pause machine motion.

Apply intended to set changes made to the coordinates or stop machine motion.

Servo Status status of pin 15 on the parallel port connector, indicates Servo Status when servo motors are attached.

USB Status this shows the current status of the USB interface.

Deselect clicking on this button toggles pin 14 on the parallel port connector.

A ON clicking on this button will toggle the relay A control signal. The status of the Relay A control signal, it is either On or Off.

B ON clicking on this button will toggle the relay B control signal. The status of the Relay B control signal, it is either On or Off.

Power clicking on this button toggles the motor power level signal line, pin 17 of the parallel port.

Kill Motion clicking on this button will kill all motion being generated by the CamPod.

Motion Status this is the status of the machine motion.

X Diff,Y Diff,Z Diff this is the difference between what was expected and what was sensed with the home limit switches on completion of the last home command.





ArmPod SuperCamXp Installation USB Driver Installation Make Acrylic Panel
Screens SideBar Menu USB Control Main Form



Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=SuperCamXp-UsbCntrl-CurStat
Copyright 2016 Dennis Bohlke
Revised 03/12/16