Taig-1161 and Taig-1162 Pulley Sets for Lathe and Mill

Taig-1161 and Taig-1162 Pulley Sets for Lathe and Mill
1161 has 3/8 bored hole for Spindle Motor shaft
1162 has 1/2 bored hole for Spindle Motor shaft
The pulley that goes on the headstock is so closely machined that it is recommended that it be heated up before putting on the headstock shaft.
Normally comes with the longer belt but short one for the mill upon request will be sent.

Taig-1161 and Taig-1162 Pulley Sets for Lathe and Mill

Taig-1161 and Taig-1162 Pulley Sets for Lathe and Mill

Taig-1161 and Taig-1162 Pulley Sets for Lathe and Mill


Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=Taig-1161-2
Copyright 2016 Dennis Bohlke
Revised 03/12/16