CamPod Wire Jumpers Change Signal Pin Assignments
Hardware Jumpers can change the Signal Pin Assignments

There are two columns of feed threws on the Printed Circuit board.
The ones on the left are the signals for the CamPod processor.
The ones on the right are for the DB25 Female connector.
By default they are connected with a trace on the board.
To change a signal pin for a given signal, cut the traces between the two columns.
Use wire to connect the connector pin to the proper CamPod Signal.
There is an open unused 14 pin DIP available.
By installing a 74LS14 in it
   Up to six(6) signals can be inverted.
   A Charge Pump signal can be created that is required by some controllers.





Home Page at http://www.super-tech.com

http://www.super-tech.com/root/grp.asp?p1=campod-jumpers
Copyright 2016 Dennis Bohlke
Revised 03/12/16